Rigging The Machine; Rig Machine Assembly - Carrier 19FA Series Installation Instructions Manual

Drain all water from oil cooler coil. See
installed. Remove the drain plug on the waterbox covers and use compressed air to remove
any water from the oil cooler coil. Follow the same procedure with the pumpout unit condenser,
if supplied.

Rigging the Machine

The 19FA machine is rigged as an entire assembly.

Rig Machine Assembly

See rigging instructions on label attached to machine. Refer to
Table 1A and Table 1B. Lift machine only from the 4 points indicated in rigging guide. Each
lifting cable or chain must be capable of supporting the entire weight of the machine.
A spreader bar may be used to reduce chain height.
WARNING
Lifting machine from points other than those specified may result in serious dam-
age to the unit and personal injury. Rigging equipment and procedures must be
adequate for machine weight. See
Note: These weights are broken down into component sections. For the complete
machine weight, add all component sections and refrigerant charge together. See
Table 1A and Table 1B
Figure
!
WARNING
Table 1A
for machine component weights.
2. Disconnect water supply line, if already
Figure 3
and Table 1B for machine weights.
and Figure 4 and