Fujitsu SPARC Enterprise T2000 Product Notes page 20

Specific Issues and Workarounds (Continued)
TABLE 1
CR ID Description
6542956 False warnings in the showenvironment table.
This occurs because the showenvironment
command, to provide timely results, does not
perform value averaging. Thus, it could appear that a
sensor or environmental reading exceeded a
threshold and did not generate a fault. If this occurs,
system logs and the showenvironment table will
not match.
6538717 The showfru command reports Micron DIMMs as
Seagate DIMMs. For example:
[LE2]FRU_PROM at
MB/CMP0/CH0/R0/D0/SEEPROM
/SPD/Timestamp: MON APR 17 12:00:00 2006
/SPD/Description: DDR2 SDRAM, 1024 MB
/SPD/Manufacture Location:
/SPD/Vendor: Seagate <--should say Micron
6520334 If SSH is not enabled, executing the ssh-keygen -l
command to print keys generates the following error
message:
sc> ssh-keygen -l -t rsa
Fingerprint file cant be opened error
380003
This error message should read as follows:
ssh is not enabled.
6508432 Many correctable errors (CE) could occur, and
although these errors are correctable, the system
could panic.
6500293, After executing boot-r, the prtdiag-v command.
6502078 might not display host bus adaptors on SPARC
Enterprise T1000 or T2000 servers.
6472072 When a panic dump is taken by Break-D of ALOM,
the panic message displays as follows:
Unrecoverable hardware error.
6408619 The server fails to boot from a Linux tftp boot server
on the network.
12 SPARC Enterprise T2000 Server Product Notes • September 2011
Workaround
Currently no workaround available. If no
warning or error message appears in the system
logs, this WARNING status can be ignored.
Currently no workaround.
Enable SSH.
Add the following entry to /etc/system to
avoid the problem:
set pcie:pcie_aer_ce_mask = 0x2001
See "Mandatory /etc/system File Entry" on
page 3.
Reboot the system without reconfiguration.
Hardware error does not occur. This message
can be safely ignored.
Use a Solaris OS tftp boot server.