Maintenance - Panasonic SC-AKX75 Owner's Manual

Remote control code
When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
Preparation
Press [RADIO, EXT-IN] (main unit: [RADIO/EXT-IN]) to
select "MUSIC PORT" or "AUX".
To set the code to "REMOTE 2"
1
Press and hold [RADIO/EXT-IN] on the main unit
and [2] on the remote control until "REMOTE 2"
is shown.
2
Press and hold [OK] and [2] for a minimum of
4 seconds.
To set the code to "REMOTE 1"
1
Press and hold [RADIO/EXT-IN] on the main unit
and [1] on the remote control until "REMOTE 1"
is shown.
2
Press and hold [OK] and [1] for a minimum of
4 seconds.
Memory reset (initialization)
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Disconnect the AC power supply cord.
2
While you press and hold [1] on the main unit,
connect the AC power supply cord again.
Continue to press and hold the button
(approximately 10 seconds) until "– – – – – – – –" is
shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.

Maintenance

To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean
this system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
13