Removing The Battery - Cub Cadet CC500 BAT Operator's Manual

Using as Mulcher
To set up the mulching attachments see the "Assembly & Set-Up"
section. For effective mulching, do not cut wet grass. If the grass
has been allowed to grow in excess of four inches, mulching is
not recommended.
Using Side Discharge
Attach the side discharge chute following the instructions in the
"Assembly & Set-Up" section. When using the side discharge, the
most effective mowing pattern is one that allows the clippings to
discharge towards the uncut part of the lawn.
Using Grass Catcher
You can use the grass catcher to collect clippings while you are
operating the mower.
1. Attach grass catcher following instructions in the
"Assembly & Set-Up" section. Grass clippings will
automatically collect in bag as you run mower. Operate
mower till grass bag is full.
2. Stop motor completely by releasing the blade/motor
control handle. Make sure that the unit has come to a
complete stop.
3. Lift discharge door and pull grass bag up and away from
the mower to remove the bag. Dispose of the grass
clippings and reinstall the bag when complete.
WARNING:
motor, and remove the key. Thoroughly inspect the
mower for any damage, and repair the damage
before restarting and operating the mower.
Excessive vibration of the mower during operation is
an indication of damage. The unit should be
promptly inspected and repaired.
14 s 5— O
ectiOn peratiOn
If you strike a foreign object, stop the

Removing the Battery

If you have two batteries, you can use one battery while the
other battery recharges. To remove the battery:
1. Remove the safety key.
2. Turn the locking knob parallel to the battery and lift the
battery off the mower base. See Fig. 5-3.
Figure 5-3
WARNING:
The battery is heavy. Lift with your legs
and not your back.
3. To seat the battery, make sure the safety key is removed,
place the battery in the battery base and turn the locking
knob to the locked position.
IMPORTANT: Use only with battery pack 925-04118.