Advertisement
CUTTING HEIGHT
The cutting height adjustment lever is located above the front
and rear left wheel.
1. Pull the cutting height adjustment lever towards wheel.
2. Move lever to desired position for a change in cutting height
(Figure 10).
Figure 10
IMPORTANT: Both the front and rear wheels must be placed
in the same relative position. For rough or uneven lawns,
move the height adjustment levers to a higher position. This
will stop scalping of grass.
3. Release lever towards deck.
WARNING
Do not at any time make any adjustment to lawn mower
without first stopping motor and removing push start
safety key.
ASSEMBLY AND SET-UP
INSTALLING BATTERY
IMPORTANT: Use only with series CC6050 or CC6025 batteries.
1. Lift up the battery housing lid.
2. Slide one battery (a) into right side battery port (b) (as
3. Push the battery firmly until the battery locks into place.
4. Repeat STEPS 2 and 3 to install a second battery (available
5. Close battery housing lid.
13
standing in front of mower) so that the battery indicator light
faces up from the battery port (Figure 11).
There should be an audible "click" when the battery is in
position.
c
Figure 11
separately) into the left side battery storage port (c).
NOTE: Left side battery storage port is for storing a second
battery. This port is not used to power the mower.
a
b
Advertisement
