Camera Installation - Honeywell HSD-361P Operation Manual

2.3 Camera Installation

2.3.1 Ribbon cable：Insert FPC socket of the cable to the relevant port of the base plate on the dome control board. (Ribbon
cable has length of 65MM and 110MM, user can select the ribbon cable according to different models of the camera) Figure 4
below illustrates the writing configuration of the ribbon/cable.
2.3.2 Install the camera module:
illustrated in Fig. 6 and Fig. 7.
Attention: Take care not to scratch the lens when installing the camera. Do make sure the camera model is the right one
for installation. Secure the camera to the corresponding screw holes as illustrated in Fig. 6, according to the model and
make of the camera, as different camera models may have different dimensions. Following the installation of the camera
module verify that it does not touch any of the dome parts including the camera shroud and acrylic dome by gently
moving the camera module along the vertical axis.
Fig.6
4
FP C
C on n e c to r
FFC
Fl e xi bl e Fl a t C ab l e
FP C
C on n e c to r
4 -PWM2 * 6
Output of ribbon cable
Install the camera module on the vertical axis tray of the dome as
Sony camera model screw holes
Honeywell camera model
screw holes
Install the camera module on the vertical
axis tray of the dome as illustrated in Fig.7
using the 4 supplied PWM2*6 Screws.
Fig.3
Fig.4
Fig.5
Insert the camera ribbon to
the camera FPC socket to
secure the connection
Fig.7
.