Assembly - NordicTrack Commercial CT User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of
the walking belt or the shipping carton. This is normal and does not affect treadmill performance. If there is lubri-
cant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys
adjustable wrench
For help identifying the assembly hardware, see the drawings below. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. To avoid damaging plastic parts, do not use power tools for assembly. Extra
hardware may be included.
3/8" Star
Washer (8)–8
1/4" x 1 3/4" Bolt (3)–2
3/8" x 2" Bolt (6)–1
1. Make sure that the power cord is unplugged.
Locate two cardboard stands. With the help of a
second person, raise the front of the treadmill
and insert the crossbar on the Base (115) into
the cutouts in the cardboard stands as shown.
Make sure that the cardboard stands are far
enough apart to support the treadmill.
Serious injury may occur if the treadmill
moves forward or backward and falls off the
cardboard stands. A second person must
hold the treadmill until assembly step 3 is
completed to prevent the treadmill from
moving, tipping, or falling.
and your own Phillips screwdriver
.
3/8" Nut (9)–2
3/8" x 1 1/4" Patch Bolt (1)–4
#8 x 3/4" Screw
1/4" x 1 1/4" Bolt (4)–2
(7)–9
3/8" x 1 3/4" Bolt (5)–1
3/8" x 3 3/4" Patch Bolt (2)–4
1
115
7
and
Cardboard
Stands