Danby Silhouette Select DIM3225BLSST Owner's Use And Care Manual page 6

Ice Maker Performance Mode Instructions (cont)
Performance
Mode
Manual drainage Manually drain the
water from the ice
system mode
box.
Direct drainage Unnecessary water
will be drained off
mode
by the outlet water
pipe on the back of
the unit
INSTALLATION INSTRUCTIONS
Instructions
Suitable situation
There is no drain hole
in the room
The height of drain hole
in the room <100mm>
Ref: Fig.A & Fig.B & Fig.C
Screw Nut and Switch
screw nut(front) (3) + seal washer(front)(4)
screw nut(back) (7) + seal washer(back) (6)
screw nut for valve seal (11)
screw nut for valve seal (12)
force water outlet switch (8)
1. Please insure the screw nut and switch are in the
above condition to avoid water leakage
2. Periodically check the Ice box (1), water level ruler(5).
If the water level exceeds the ruler water level,please
drain off the unnecessary water.
3. When draining off the water, you can remove the Ice
box(1), screw nut(front)(2) and seal washer(front)(4)
use the holder to take out the unnecessary water, then
tighten the above screw and seal washer.
Ref: Fig.A & Fig.B & Fig.C
Screw Nut and Switch
screw nut(front) (3) + seal washer(front)(4)
screw nut(back) (7) + seal washer(back) (6)
screw nut for valve seal (11)
screw nut for valve seal (12)
force water outlet switch (8)
100mm 1. Please insure the screw nut and switch are in the
above condition;
2. Use a certain length drain pipe,connect one side to
the direct water outlet pipe connection (13) the other
to the drain hole. Please insure the connection is tight
to avoid water leakage.
4
Operation instruction
Condition
lock
lock
lock
lock
OFF
Condition
lock
open
lock
open
OFF