Storing Your Brewer; Water Reservoir; Internal Components - Bunn Trifecta MB Use & Care Manual

pERIOdIC CLEANING
IMPoRtANt: do not force the Strainer into position. It will only fit properly into the water Reservoir
one way. If the Strainer does not drop all the way to the bottom, rotate 180º and try again.
1. Remove Strainer by gently rocking it from side to side while pulling it out of the

water Reservoir.

2. wash both parts with warm soapy water and a soft
lint free towel. be careful not to get debris in the mesh
screen area of the strainer or in the bottom area of the
water Reservoir.
3. thoroughly rinse with clean water.
4. Allow to air dry.
5. Replace Strainer by dropping into the water Reservoir
and gently rocking side to side while pushing down.
1. Separate the Strainer from the water Reservoir.
2. Place on the top rack.
3. when clean and dry, re-install Strainer into the water Reservoir. Confirm that there
is no debris under the Strainer or in the bottom area of the water Reservoir.
1. Rinse the inside of your brew Chamber thoroughly to remove any particles.
2. Using a flat head screw driver, gently rotate the brew Screen counterclockwise
180 degrees and remove from the brew Chamber.
be careful not to damage the metal screen material
when using a tool or cleaning the brew Screen.
3. wash with warm soapy water and a soft lint free towel.
4. Gently place the brew Screen back into position in the
bottom of the brew Chamber. with a flat head screw driver gently push down
and rotate clockwise until brew Screen is secure.
deep clean your brewer at least every 3 months. Mineral deposits may accumulate
due to impurities in the water used to brew. If deposits are not removed, they
can impair the operation of the brewer and reduce product life. the frequency
of cleaning depends on the mineral content of your water (the higher the mineral
content -- the more often you should deep clean).
1. Remove water Reservoir Lid and fill water Reservoir with 12 oz. white vinegar
2. Replace water Reservoir Lid.
3. Push brew button to cycle vinegar through the brewer.
4. Run at least 5 brew Cycles with water only to flush remaining vinegar from the
internal system.
8
WATER RESERvOIR
hANd CLEANING
dIShWAShER CLEANING
BREW ChAMBER FILTER SCREEN
dEEp CLEANING

INTERNAL COMpONENTS

continued
Place screw driver tip in
center slot of Brew Screen.
trifecta MB coffee and tea Brewer
®