Denon AVR-S500BT Owner's Manual page 80

Contents Connections
3
Connect the Sound calibration microphone to the
SETUP MIC jack of this unit.
When the Sound calibration microphone is
connected, the following screen is displayed.
Auto Setup
Your AVR can automatically measure the
acoustics of your room and the optimize
your speakers.
Start
4
Select "Start", then press ENTER.
Front panel Display
Playback Settings
5
Select "Next", then press ENTER.
6
Select "Begin Test", then press ENTER.
If "Caution!" is displayed on TV screen:
Go to "Error messages" (v p. 81). Check any related items, and
perform the necessary procedures.
n
A Press BACK to display the popup screen.
B Press o to select "Yes", then press ENTER.
7
Unplug the Setup and measurement microphone from
the unit's SETUP MIC jack.
Do not change the speaker connection or subwoofer volume after
"Auto Setup". If these are changed, run "Auto Setup" again in order
to configure the optimum equalizer settings.
Rear panel 80
Tips
Measurement requires several minutes.
0
NOTE
To cancel Auto Setup
Remote Index
Appendix