Differential; Revo Mix (Revolution Mix); Master/Slave Information To Operate The Dx6I As A Master; To Operate The Dx6I As A Slave - Spetrum DX6i Instruction Manual

EN

DIFFERENTIAL

The Differential function decreases the amount an aileron moves
down without affecting the amount the other aileron moves up.
This can decrease swerving (adverse yaw) tendencies during roll
maneuvers.
Differential is not available in this transmitter for flying-wing
airplanes (ELEVON option in WING TAIL MIX).
Note: Use of the Differential function requires choosing
DUALAILE in WING TAIL MIX function.

REVO MIX (Revolution Mix)

Revo Mix mixes tail rotor input and throttle/collective input to
counteract main rotor torque. This function has UP and DN
(down) revolution mixing for flight modes NORM and STUNT.
Move the F MODE switch to activate a flight mode.
Note: Use REVO MIX only for non-heading hold gyros.
Note: Move Throttle stick slowly. Ignore turning of helicopter
nose when first moving throttle.
Adjust for middle-to-high throttle settings:
1. Put helicopter in a stable hover with tail rotor trim (rudder) at
center.
2. Increase throttle to start a stable climb.
3. When helicopter nose turns, change UP setting so nose
does NOT turn.
Adjust for middle-to-low throttle settings:
1. At a safe height, decrease throttle so helicopter falls slowly.
2. When helicopter nose turns, change DN setting so nose
does NOT turn.
MASTER/SLAVE INFORMATION
To operate the DX6i as a master:
• Transmitter batteries fully charged.
• Bind the transmitter to the model.
• Connect the trainer cord (SPM6805) to the back of the
transmitter.
• Make sure the slave transmitter batteries are fully charged.
• Make sure the slave transmitter is powered off; the slave
transmitter receives power when you connect the trainer
cord. At this point, the slave will not transmit a signal to the
model.
• Move and hold the master transmitter's trainer switch to
give model control to a slave transmitter.
• The trainer switch is on the back left of the transmitter
(Mode 2, used in USA or on the right side on Mode 1 trans-
mitters).
• Release the trainer switch to give model control to the
master transmitter.
18
DIFFERNTIAL
DUALAILE RATE
A Option value (0-100%)
REVO MIX
A
NORM
UP
C
DN
B
A F Mode switch position ( = active)
B Option values ( 100 to 0 to 100)
C Direction of helicopter movement

To operate the DX6i as a slave:

• Make sure transmitter batteries are fully charged.
• Make sure transmitter is powered ofF
• Connect the trainer cord between the master and slave
transmitters.
• The DX6i screen will show information, but the transmitter
will not send a signal to the model.
• Both transmitters must be programmed to control the
model.
NOTICE: You must set up a model the same in both transmitters
before using the trainer cord. The trainer cord does not copy
model control values from one transmitter to another.
SPEKTRUM DX6i • RADIO INSTRUCTION MANUAL
List
A
0%
List
STUNT
0% UP 0%
0% DN 0%