Sony MDS-JA30ES Service Manual page 12

4-4-2. Operating the Continuous Recording Mode
1. Entering the continuous recording mode
1 Set the MO disc in the unit.
2 Rotate the AMS knob and display "CREC MODE".
3 Press the YES button to change the display to "CREC IN".
4 When access completes, the display changes to "CREC (
Note : The " " displayed are arbitrary numbers.
2. Changing the parts to be recorded
1 When the YES button is pressed during continuous recording, the display changes to "CREC MID", "CREC OUT" and
off.
When pressed another time, the parts to be recorded can be changed.
2 When access completes, the display changes to "CREC (
Note : The " " displayed are arbitrary numbers.
3. Ending the continuous recording mode
1 Press the NO button. The display changes to "CREC MODE" and
2 Press the §OPEN/CLOSE button and remove the disc.
Note 1 : The recording start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
Note 2 : The NO button can be used to stop recording anytime.
Note 3 : During the test mode, the erasing-protection tab will not be detected. Therefore be careful not to set the continuous recording
mode when a disc not to be erased is set in the unit.
Note 4 : Do not perform continuous recording for long periods of time above 5 minutes.
Note 5 : During continuous recording, be careful not to apply vibration.
4-4-3. Non-Volatile Memory Mode
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If set accidentally, press the NO button immediately to exit it.
4-5. Functions of Other buttons
Function
·
Sets continuous playback when pressed in the STOP state. When pressed during continuous playback, the tracking servo turns ON/OFF.
p
Stops continuous playback and continuous recording.
)
The sled moves to the outer circumference only when this is pressed.
0
The sled moves to the inner circumference only when this is pressed.
r
Turns recording ON/OFF when pressed during continuous playback.
SCROLL/ Switches between the pit and groove modes when pressed.
CLOCK SET
PLAY MODE Switches the spindle servo mode (CLVS and A).
DISPLAY/ Switches the display when pressed.Returns to previous step. Stops operations.
CHAR
Note : The erasing-protection tab is not detected during the test mode. Recording will start regardless of
the position of the erasing-protection tab when the r button is pressed.
" an lights up.
REC
" and lights up.
REC
goes off.
REC
Contents
— 12 —
goes
REC