Advertisement
You can mark track numbers either manually
or automatically.
By marking track numbers at
specific points, you can quickly locate the
points later using the AMS Function or Editing
Functions.
When using the remote, set SELECT to CDR.
I
,
c
SELECT
000
000
000
000
I=&
REC 0
mm
11
EJIEFJ
Qa
00
Marking
track numbers
manually
You can mark track numbers at any time while
recording.
Press REC 0 at the point you want to add a
track mark while recording.
Notes
l
You cannot mark track numbers manually during
Synchro-Recording.
l
Track length must be at least 4 seconds to mark
@ack numbers manually.
Marking
track numbers
automatically
(Track Marking
Function)
The unit adds track marks differently in the
following cases:
l
When you make
a Synchro-Recording
(Page
18)
The unit marks track numbers automatically under
the control of DECK A.
l
When
recording
from a CD or MD
connected
through
the DIGITAL
OPTICAL
IN or DIGITAL
COAXIAL
IN jack
(with
"OPTICAL"
or "COAXIAL"
selected
by the INPUT
button)
The unit marks track numbers automatically
according to the information contained in the source
being recorded. However, the unit may not
automatically mark track numbers when recording
from some CD players and multi disc players.
l
In all other
cases
When "Track Mark" is set to "LSync" in Setup
Menu, the unit marks a new track number whenever
the signal drops to the specified level* or below for
about
1.5 seconds or longer, then rises to a specified
level.
* The initial setting is -50 dB.
To turn
off the
Track
Mark
Function
While the unit is stopped, set "Track Mark" in
Setup Menu to "Off." For details, see "Using
the Setup Menu" (page 28).
To change
the
trigger
level
for
Track
Marking
Function
While the unit is stopped, select "LSync Lvl"
in Setup Menu and set the level between
-72 dB and -20 dB. For details, see "Using the
Setup Menu" (page 28).
22
Advertisement
