Marantz SR5009 Owner's Manual page 215

Contents Connections
Symptom
Dolby PLg mode or DTS It cannot be selected when "Speaker Config." - "Center" or "Surround" is set for "None".
0
Neo:6 mode cannot be
Dolby PLg or DTS Neo:6 cannot be selected when using headphones.
0
selected.
Audyssey MultEQ ® XT, These cannot be selected when you have not performed Audyssey
0
Audyssey Dynamic EQ ®
Switch to a sound mode other than "Direct" or "Pure Direct".
0
and Audyssey Dynamic
These cannot be selected when using the headphones.
0
Volume ® cannot be
selected.
"M-DAX" cannot be Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
0
selected. multichannel signals such as Dolby Digital or DTS surround, "M-DAX" cannot be used.
Switch to a sound mode other than "Direct" or "Pure Direct".
0
No sound is output when Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL)
0
using ZONE2. cannot be played back. Use analog connections.
When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the
0
Bluetooth device and this unit and use it within a range of about 10 m.
Front panel Display
Playback Settings
Cause / Solution
Rear panel 215
Tips
® Setup.
Remote Index
Appendix
Page
182
－
171
112
－
148
112
－
－