The Pre-Recording Function; Cutting Out Low Frequency - The Lcf Function - Sony ICD-SX700 Operating Instructions Manual

DNotes
• If you start recording with pre-recording
function using the built-in microphones,
a click noise may be recorded when you
press. (record/pause). To record with pre-
recording function, we recommend using an
external microphone.
• When the remaining recordable time is less
than 10 seconds, the pre-recording function
is disabled.
• When 60 minutes have passed after the
Ie
recorder entered the standby mode,
the standby mode will be cancelled and
recording stops.
• If you stop recording before step 8, sounds
buffered in the memory will not be saved.
To cancel the pre-recording
function
Set "PRE REC"to "OFF" in step 4.
Cutting out Low
Frequency - the LCF
Function
When you set the LCF (Low Cut Filter)
function to "ON" in the stop or recording
mode, you cut out a frequency of lower
than 200 Hz to reduce the roaring noise
from wind, etc., this helps to record a
sound source more clearly.
The LCF function is set to "OFF"when you
purchase the IC recorder.-
I