Recording Sound From A Telephone Or A Cell Phone - Sony ICD-SX700 Operating Instructions Manual

2
Press ...... or ~ to select
IIMIC IN:'
then press
~
•.
3
Press. (record/pause) to start
recording.
The built-in microphones are
automatically cut off.
If the input level is not strong enough,
adjust the recording level on the IC
recorder.
When a plug in power type
microphone is connected, power
is automatically supplied to the
microphone from the IC recorder.
DNote
If"SELECT INPUT" is not displayed, set it in the
menu (page 88).
'Q'
Recommended microphones
You can use the Sony ECM-CS 10, or ECM-CZl
°
electret condenser microphone (not supplied).
Recording sound from a
telephone or a cell phone
You can use the ECM-TL 1 headphone-
type electret condenser microphone
(not supplied) to record sound from a
telephone or a cell phone.
Insert the earphone of the microphone
into your ear, then, while holding the
receiver to the ear with the earphone in
it, connect the plug of the earphone to
the ., jack of the IC recorder.
DNotes
• After you have made the connection, check
the sound quality of the conversation
and the recording level before you start
recording.
• If the beep of the telephone or a dial tone is
recorded, the conversation may be recorded
with lower level of sound. In this case, start
recording after the conversation has started.
• The VOR function may not work, depending
on the kind of telephone or the line
condition.
• We assume no responsibility whatsoever
for any inconvenience, even if you cannot
record a conversation using the IC recorder.
• Your dealer may not handle some of the
above listed optional accessories. Please ask
the dealer for detailed information.
MIC IN
AUDIO IN
I
•
MIC IN