Table of Contents
Advertisement
lowing pages contain suggested maintenance information and schedules which the operator should follow on
a routine basis.
Remain alert for unusual noises, they could be signaling a problem. visually inspect the machine for any
abnormal wear or damage. A good time to detect potential problems is while performing scheduled mainte-
nance service. Correcting the problem as quickly as possible is the best insurance.
Clear away heavy build-up of grease, oil and dirt, especially in the engine and under the seat platform
areas; minute dust particles are abrasive to close-tolerance engine and hydraulic assemblies.
Daily inspect mower for grass clippings and wire and string tangles. The underside of the mower deck will
collect a build-up of grass clippings and dirt, especially when grass is wet or has high moisture content. This
build-up will harden, restricting blade and air movement and will probably show a poorer quality of cutting.
Therefore, it should be removed routinely.
To do this, it will be necessary to raise and block the deck, using jack stands or blocks, in the full up posi-
tion and scrape the build-up from underneath.
Some repairs require the assistance of a trained service mechanic and should not be attempted by
unskilled personnel. Consult your Hustler service center when assistance is needed.
Torque values
WARNING:
spindle bolts. Failure to correctly torque these items may result in the loss of a wheel or blade,
which can cause serious damage or personal injury.
Torque values given below:
Wheel (lug) nuts
Blade spindle top bolt
Blade spindle bottom bolt
It is recommended that these be checked after the first 2 hours of operation, initially and every 50 hours
following removal for repair or replacement.
For all other torques refer to the torque call out chart located elsewhere in this manual.
For engine torque values, see engine owner's manual.
Tires
It is important for level mowing that the tires have the same amount of air pressure. The recommended
pressures are:
PSI
Drive Tires
8-12
Front Wheels
8-12
Solid fill tires are not recommended for Hustler turf equipment. On any machine, with solid filled tires, the warranty claim will be
denied.
WARNING:
attempt to mount a tire without the proper equipment and experience to perform the task. Always
maintain the correct tire pressure and never over inflate. Never weld or heat a wheel and tire
assembly as an explosion may occur. Welding can weaken or deform a wheel. When inflating tires
stand to one side and not in front of or over the tire assembly. Check tires for low pressure,
blemishes, damaged rims, or missing lug bolts and nuts.
Lubrication
1. Grease the front wheel bearings per the Maintenance Schedule. Use SAE multi-purpose grease.
2. Grease the four deck lift pivots, located to the side of the operator's footrest per the Maintenance
Schedule. Use SAE multi-purpose grease.
Electrical system
333559 09/08
Particular attention must be given to tightening the drive wheel lug nuts and blade
Ft.-lbs.
Nm
65-75
88.14-101.7
118
160
118
160
Explosive separation of a tire and rim can cause serious injury or death. Do not
9-9
Hide quick links:
Advertisement
Table of Contents
