Start- -Up Checklist - Carrier Infinity 50XT-A Installation Instructions Manual

I. PRELIMINARY INFORMATION
MODEL NO.:
SERIAL NO.:
DATE:
TECHNICIAN:
II. PRESTART- -UP (Insert check mark in box as each item is completed)
( ) VERIFY THAT ALL PACKING MATERIALS HAVE BEEN REMOVED FROM UNIT
( ) REMOVE ALL SHIPPING HOLD DOWN BOLTS AND BRACKETS PER INSTALLATION INSTRUCTIONS
( ) CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS
( ) CHECK THAT INDOOR (EVAPORATOR) AIR FILTER IS CLEAN AND IN PLACE
( ) VERIFY THAT UNIT INSTALLATION IS LEVEL
( ) CHECK FAN WHEEL, AND PROPELLER FOR LOCATION IN HOUSING/ORIFICE AND SETSCREW TIGHTNESS
( ) MAKE SURE THAT - - (If Applicable) ON 60 SIZE PURON HEAT PUMP ONLY, THE TWO WIRE TIES FASTEN TO THE
OUTDOOR COILS AND REVERSING VALVE/ACCUMULATOR HAVE BEEN REMOVED
III. START- -UP
ELECTRICAL
SUPPLY VOLTAGE
COMPRESSOR AMPS
INDOOR (EVAPORATOR) FAN AMPS
TEMPERATURES
OUTDOOR (CONDENSER) AIR TEMPERATURE
RETURN- -AIR TEMPERATURE
COOLING SUPPLY AIR
HEAT PUMP SUPPLY AIR __________________
ELECTRIC HEAT SUPPLY AIR_______________
PRESSURES
REFRIGERANT SUCTION
REFRIGERANT DISCHARGE
( ) VERIFY REFRIGERANT CHARGE USING CHARGING CHARTS
( ) TEMPERATURE RISE (See Literature) RANGE _______________
( ) MEASURED TEMPERATURE RISE ____________
* Measured at suction inlet to compressor
{ Measured at liquid line leaving condenser.

START- -UP CHECKLIST

(Remove and Store in Job Files)
DB
DB
DB WB
PSIG, SUCTION LINE TEMP*
PSIG, LIQUID TEMP{
29
WB