Operating Instructions; Grill Lighting Instructions - Nexgrill 720-0133-NG Use And Care Manual

GENERAL USE OF THE GRILL
Each main burner is rated at 12,000
Btu/hr. The main grill burners
encompass the entire cooking area and
are side ported to minimize blockage
from falling grease and debris. Above
the burners are stainless steel radiants
(flame covers). The igniter knobs are
located on the lower center portion of
the valve panel. Each rotary igniter is
labeled on the control panel.
USING THE GRILL
Grilling requires high heat for searing
and proper browning. Most foods are
cooked at the "HI" heat setting for the
entire cooking time. However, when
grilling large pieces of meat or poultry,
it may be necessary to turn
WARNING: IMPORTANT!
BEFORE LIGHTING...
Inspect the gas supply hose prior to
turning the gas "ON". If there is evidence
of cuts, wear, or abrasion, it must be
replaced prior to use. Do not use the grill
if the odor of gas is present. Only the
pressure regulator and hose assembly
supplied with the unit should be used.
Never substitute regulators for those
supplied with the grill. If a replacement is
necessary, contact the factory for proper
replacement.
16

OPERATING INSTRUCTIONS

GRILL LIGHTING INSTRUCTIONS

the heat to a lower setting after the initial
browning. This cooks the food through
without burning the outside. Foods cooked
for a long time or foods basted with a
sugary marinade may need a lower heat
setting near the end of the cooking time.
NOTE: This stainless steel grill is designed
to grill efficiently without the use of lava
rocks or briquettes of any kind. Heat is
radiated by the stainless steel flame tamers
positioned above each burner.
NOTE: The hot grill sears the food, sealing
in the juices. The longer the preheat, the
faster the meat browns and the darker the
grill marks.
DO NOT LEAVE THE GRILL
UNATTENDED WHILE COOKING.
TO LIGHT THE GRILL BURNER:
Always keep your face and body as far
from the grill as possible when lighting.
Your stainless steel grill has a fully automatic
ignition to ignite each burner. Push and turn
each burner knob slowly to high,the electronic
spark will repeatedly fire until the burner
ignites .