Power - Hanns.G HL190 User Manual

HL269
INSTALLATION:
1. Turn the monitor over and set it upside down.
2. Insert the bracket into the slot on the display.
3. Using a screwdriver, secure the 4 screws clockwise to fix the bracket to the display. Make sure
the screws are all tightened.
4. Align the slot on the base with the bottom of the bracket.
5. Pull the screw ring upwards, then turn the screw clockwise to secure. When the stand is securely
attached to the monitor, pull down the screw ring to flatten it with the base of the screw.
6. Check the underside of the stand to ensure that the monitor has been firmly installed to the stand
and that the screws do not loosen.
REMOVAL:
1. Turn the monitor over and set it upside down.
2. Using your hands, remove the screws securing the display to the base by turning them
counterclockwise. Then, remove the base.
3. Using a screwdriver, remove the 4 screws securing the display to the base by turning them
counterclockwise.

POWER

POWER SOURCE:
1. Make sure that the power cord is the correct type required in your area.
2. This LCD monitor has an Internal universal power supply that allows operation in either
100/120V AC or 220/240V AC voltage area (No user adjustment is required.)
3. Connect the AC-power cord one end to your LCD monitor's AC-input socket, the other end to
wall-outlet.
INSTALL
Figure.2. Installing and Removing the Base
REMOVE
9
User's Manual