Control Shaft Replacement - White Outdoor ZT Zero 17 Service Manual

For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983
15.9. Remove the hairpin clip from the brake rod at the
deck lift shaft. Remove the rod from the shaft
bracket. Do this for both brake rods. See Figure
15.9.
Brake Rod
Figure 15.9
15.10. Remove the nine hex washer head tapp screws
securing the seat box frame to the frame of the
unit. See Figure 15.10.
Screws
Figure 15.10
15.11. Slide the seat box frame forward to allow
removal of the fuel tank.
15.12. Once the fuel tank is removed from the unit, dis-
connect the fuel line from the fuel pump and
carefully remove fuel tank from unit.
NOTE: Make sure to clean up any spilled fuel.
NOTE: During reassembly be certain to recon-
nect electrical connector and fuel line.
NOTE: This would be a good time to change the
fuel filter.
Hairpin Clip
15
www.mymowerparts.com
16.

CONTROL SHAFT REPLACEMENT

16.1. Disconnect the - (negative) lead to the battery.
16.2. Remove appropriate side console. Refer to
"CONSOLE REMOVAL" section of this manual.
16.3. Disconnect the ferrule from the return to neutral
assembly. See Figure 16.3.
Figure 16.3
16.4. Remove hex head cap screw and flat washer
securing the control hub to the control shaft.
See Figure 16.4.
Figure 16.4
16.5. Remove hair pin securing the lapbar control rod
to the control hub.
Ferrule
Cap Screw