Table of Contents
Advertisement
Installation
Positioning the tumble dryer
The tumble dryer can be free-standing or in a
stack. Remember that the tumble dryer produces
heat and should therefore not be located in a room
that is too small. If the room is very small, drying
will take longer due to the limited quantity of air.
WARNING!
• Any electrical installation must be carried out
by qualified professionals.
• The machine must not be installed behind a
lockable door, a sliding door or a door with
hinges on the opposite side to those of the
tumble dryer.
• The tumble dryer's plinth ventilation must not
be blocked by a rug or the like.
NOTE!
To improve ventilation, leave the door to the
room where the tumble dryer is located open.
Freestanding
The tumble dryer can be positioned beside the
washing machine.
Stacking
The tumble dryer can be placed on top of a ASKO
washing machine. Use the two foot cups found in
the document bag included with the machine and
the two tip guards attached to the bottom left
corner of the back of the machine.
How to assemble the stack:
1. Undo the anti-tilt device.
2. Undo the two screws indicated on the back of
the washing machine.
3. Secure the anti-tilt device using the screws as
shown in the picture.
4. Attach the plastic cups for fixing the tumble
dryer's front feet to the washing machine's top
cover. This is essential, as only when the
tumble dryer's feet are resting in the plastic
cups can you be sure that the tumble dryer is
correctly positioned on the washing machine.
Break off tag A on the cup fitted on the
right-hand side and tag B on the cup fitted on
the left-hand side. Then remove the paper from
the self-adhesive surface under the plastic
cups.
A
A
B
B
25
Advertisement
Table of Contents
