Connection Manager - Cradlepoint MBR1400 Product Manual

MBR1400 | USER MANUAL – Firmware version 4.2
CRADLEPOINT

7.1 Connection Manager

The router can establish an uplink via the Ethernet WAN port, WiFi as WAN, or modems plugged into a modem port. If the
primary WAN connection fails the router will automatically attempt to bring up a new link on another device. This feature is
called failover. If Load Balance is enabled, multiple WAN devices may be plugged in and each may establish a link.
WAN Interfaces
7.1.1
This is a list of the available interfaces used to
access the Internet. You can enable, stop, or
start devices from this section. By using the
priority arrows (the arrows in the boxes to the
left—these show if you have more than one
available interface), you can set the interface the
router uses by default and the order that it allows
failover.
In the example shown, Ethernet is set as the primary Internet source, while a USB modem is attached for failover. The
Ethernet is "Unplugged" while the modem is "Connected."
Load Balance: If this is enabled, the router will use multiple WAN interfaces to increase the data transfer throughput by
using any connected WAN interface consecutively. Selecting Load Balance will automatically start the WAN interface and
add it to the pool of WAN interfaces to use for data transfer. Turning off Load Balance for an active WAN interface may
require the user to restart any current browsing session.
Enabled: Selected by default. Deselect to disable an interface.
Click on the small box at the top of the list to select/deselect all devices for either Load Balance or Enabled.
Click on a device in the list to reveal additional information about that device and to enable configuration options.
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 120