Table of Contents
Advertisement
Chapter 6: Creating and Editing Sounds
Editing a Sound
This allows you to edit a sound loaded from a disk or sampled into the memory.
Hold down SHIFT and press TRIM (or 5 on the numeric pad), the TRIM mode screen appears.
Snd:loop_1
.........................................................
St:
TRIM
Sound display and order can be changed while in the TRIM, LOOP or ZONE screens, by press-
ing the TRIM, LOOP or ZONE key again (example: F2 in the LOOP page) The display can be
toggled between Memory (order recorded in memory), Size (order of file size), Name (alphabetical
order).
Selecting a Sound
Move the cursor to the Snd: field and select the sound by rotating the DATA wheel. With stereo
samples, (ST) will appear after the sample name.
Renaming or Displaying the Specification of the Sound
To open the Sound window, select the Snd: field and press OPEN WINDOW.
•
Sound name:
This changes the name of the sound.
Tap a drum pad or rotate the DATA wheel to display the name window.
Enter a name and press the ENTER key to confirm.
Note: If you do not press ENTER and move to another page, the name will not be
saved.
105
End:
LOOP
ZONE
......................................................................................................
Sound
Sound
Sound name:
name:loop_1
.....................................................................................................
<Sound spec.>
<Sound spec.>
Type:MONO
DELETE CONVRT
........................................................................................................
Page 93
(ST)
PLAY X:ALL
PLAY X:ALL
85242
View:LEFT
PARAMS
EDIT
PLAY X
PLAY X
Rate: 44100Hz
Rate: 44100Hz
Size:862kbytes
CLOSE
COPY
Advertisement
Table of Contents
