Advertisement
o o p p e e r r a a t t i i n n g g s s e e t t t t i i n n g g s s r r e e m m o o t t e e c c o o n n t t r r o o l l c c o o d d e e l l e e a a r r n n i i n n g g
Many of the operating settings of this unit are programmable. They can be changed whenever necessary through
Operating Settings Remote Control Code Learning. The Valet®/Program push-button switch, plugged into the blue
port, is used together with a programmed transmitter to change the settings.
The operating settings dictate how the unit operates. It is possible to access and change any of the feature set-
tings using the Valet®/Program switch.
T T o o e e n n t t e e r r O O p p e e r r a a t t i i n n g g S S e e t t t t i i n n g g s s C C o o d d e e L L e e a a r r n n i i n n g g : :
1.
2.
2.
4.
2 2 2 2
O O p p e e n n a a d d o o o o r r . . ( ( The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)
I I g g n n i i t t i i o o n n . . Turn the ignition on, then back off. (The H1/9 YELLOW switched ignition input
must be connected.)
C C h h o o o o s s e e . . Within 10 seconds, press and release the Valet
times corresponding to the feature number you want to program (see the Features Menu
section of this guide). The LED ON settings listed in the Features Menu table are the factory
default settings.
Once the Valet/Program switch has been pressed and released the number of times corre-
sponding to the feature you wish to program, press it once more and H H O O L L D D it. After a
second, the LED will flash to indicate which feature you have accessed. For example, groups
of five flashes would indicate access to Feature 5. The siren will also chirp five times.
T T r r a a n n s s m m i i t t . . While H H O O L L D D I I N N G G the Valet®/Program switch, you can select the desired feature
settings using the remote transmitter. As shipped, the unit is configured to the default LED
ON settings. Pressing Button I while H H O O L L D D I I N N G G down the Valet/Program switch will program
the feature to the LED ON settings. The siren will chirp once to indicate the one-chirp
setting has been selected. Pressing Button II while H H O O L L D D I I N N G G down the Valet/Program
switch will change the setting to the LED OFF setting. The siren will chirp twice indicating
that the LED OFF setting has been selected.
®
/Program switch the number of
© 2004 Directed Electronics, Inc. Vista, CA
Advertisement
