Changing The Fuse; Customer Service; Technical Data - Silvercrest PAC-10 Instruction Manual And Safety Instructions

In addition, the loudspeaker system has an EFFECT LOOP.
This consists of two jack sockets (6.3 mm). One of the two sockets is labelled SEND UNBAL (18) and the other is
labelled RETURN UNBAL (17).
One or more external effects can be added to the overall result by using this EFFECT LOOP.
You will need an additional external effects device. The SEND UNBAL socket (18) is connected to the input of the
external effects device and the RETURN UNBAL socket (17) with the output of the external effects device.
You will need a 6.3 mm jack plug for both of the EFFECT LOOP sockets. Ask beforehand about the correct plug
connectors for the external effects device you use, as these may vary.

6. Changing the fuse

The fuse is located next to the connection of the main input jack.
Please make sure that the device is unplugged before you open the compartment. Is that the case, open the
compartment and pull it out. In the front part of the fuse insert you will find the spare fuse. The back contains the
one currently used. Unclip the defective fuse and replace it with the new one. Afterwards close the compartment
and make sure that it clicks into place.
Important! Only use fuses that are identical in construction.

7. Customer Service

Should the loudspeaker system malfunction in spite of carefully following this guide, please ring us on the Customer
Service telephone number, +49 (0)7731 790118.

8. Technical Data

Power Output: 50 W (RMS) (4 Ω)
Frequency range: 70 Hz-18 kHz
Max. Acoustic Pressure: 93 dB
Power Input: 100 W
Power Supply: AC 230 V / 50 Hz.
2-Way System: 1x 10" woofer and 1x 1" tweeter
Dimensions (H x W x D): 640 x 480 x 305 mm
Weight: 22.5 kg
˜
6