Table of Contents
Advertisement
on has +12 Volt switched parking lights, connect this wire to a fused + 12 Volt source. (Max. 15 Amps)
NOTE: If the vehicle's parking lights are ground switched, connect this wire to chassis ground.
Parking Light Wiring Detail
6 White w/ Black Trace Wire: (+) Optional Siren Output
This is the positive siren feed wire. Route this wire through a grommet in the firewall to the siren location.
Connect the White w/ Black Trace wire to the Red wire of the Siren. Secure the Black wire of the Siren to
a known chassis ground or solid clean metal surface.
7 Black w/ White Trace Wire : 300 mA Horn Output
The black w/ white trace wire is provided to beep the vehicle's horn. This is a transistorized low current
output, and should only be connected to the low current ground output from the vehicle's horn switch.
If the vehicle uses a + 12 VDC horn switch, then connect the black w/ white trace wire to terminal 86 of the
AS 9256 relay (or an equivalent 30 Amp automotive relay), and connect relay terminal 85 to a fused
+ 12 VDC battery source. Connect relay terminal 87 to the vehicle's horn switch output, and connect relay
terminal 30 to a fused + 12 VDC battery source.
8 Green w/ Orange Trace Wire: Tachometer Input Signal
This wire will continually monitor the engine's tach rate while the unit is under power of the Remote Start
module. This wire will be routed to the vehicle ECM tach input or through the firewall into the engine
9
128-8971a
9 of 32
Hide quick links:
Advertisement
Table of Contents
