Table of Contents
Advertisement
4. Reset and restart the switch as described in "Resetting and restarting the
Resetting and restarting the switch
To activate the new image or images, you must reset the switch. To reset the
switch, complete the following steps.
1. Log on to the IBM Flex System Chassis Management Module (CMM) CLI as
2. Set the environment to the bay where you installed the switch. For example:
3. Type the reset command to restart the switch. Wait approximately 100 seconds
4. Type the info command for the switch that was just restarted and note the
Acquiring feature licenses
The base option supports twenty-two total data ports (fourteen compute node ports
and eight uplink ports). Upgrade licenses are available that enable the use of
additional ports on the switch:
v Upgrade 1 - This upgrade feature adds an additional fourteen compute node
v Upgrade 2 - This upgrade feature adds an additional fourteen compute node
Upgrade licenses are unique to each switch and are non transferable.
Where yyyy is the boot image file name.
switch."
described in the switch's User's Guide or CLI Reference Guide for the CMM. If
necessary, obtain the IP address of the management module from your system
administrator.
system> env -T system:switch[1]
for POST to complete.
system:mm[1]> env -T system:switch[1]
system:switch[1]> reset
corresponding level of the firmware for the switch. Confirm that the firmware
build number reflects the correct firmware release. For example:
system:switch[2]> info
...
Boot ROM
Rel date:
Version:
Status:
Main application
Rel date:
Version:
Status:
Main application
Rel date:
Version:
Status:
ports and two 40 Gb uplink ports (also usable in four 10 Gb mode) to the base
product.
ports and six uplink ports to the base product.
Note: Upgrade 1 and Upgrade 2 are independent and can be installed in any
order, with or without the other.
04/02/2013
7.7.1.12
Active
04/02/2013
7.7.1.12
Active
03/22/2013
7.7.1.12
Inactive
Chapter 4. Updating the firmware and licensing
29
Advertisement
Table of Contents
