Holland Apex BH421-SS5 Vinstruction Manual page 9

Table of Contents

Advertisement

FIGURE 6
Step 8.
Refer to Figure 8. Select the following items:
1. drip pan
2. drain pipe
3. drain valve
Install the drain pipe into the female threaded coupling in the right end
of the drip pan. Tighten with pliers or pipe wrench.
Carefully set the drip pan into grill bottom using the lift tabs at each
end. Line up the drain pipe with the hole in the grill bottom making sure
pipe extends out bottom and drip pan is setting level in its brackets.
Install the brass drain valve onto the drain pipe. Hand tight only is
sufficient. DO NOT TIGHTEN WITH WRENCH OR PLIERS! (During
the course of maintenance of the grill you will need to remove the
drain valve.)
Now place your cooking grid into the grill.
Step 9.
Refer to Figure 8. Select the following items:
1. condiment tray
2. utensil hooks (3 ea)
Open cabinet door and insert utensil hook in upper hole of door liner
and rotate downward to allow peg on back side of hook to engage
lower hole. Repeat for other 2 hooks.
Then insert tab hooks on condiment tray into slots in door liner. Allow to
drop down to lock into position.
Install chip tray as shown.
10 -24 x 1" Carriage bolt
10 -24 Hex Nut
and Lock Washer
Shelf Bracket
4. cooking grid
5. drip bucket
3. chip tray
Cooking Grid
Drip Pan
FIGURE 8
Utensil Hook
Condiment Tray
Tank Installation
Place your 20-lb propane tank into
the hole in cabinet base.
Connect the regulator and hose
assembly to the propane tank
valve. This connection is made by
the QCC-1 fitting. The large black
plastic nut fits over the outside of
the tank valve threads and turns
right or clockwise to tighten. No
tools are needed. Hand tight is
sufficient.
If a good connection is not
achieved, the safety valve inside
will not permit the proper amount
of gas to flow.
Next attach and adjust downward
the Tank- Hold-Down bracket (see
Figure 9) to secure the tank.
Secure with 1/4-20 x 1/2 thumb
screw.
Check all bolts and nuts for tightness and then proceed
to leak testing.
Drain Pipe
Chip Tray
Drain Valve
Screws onto drain pipe
Hand tighten only
Drip Bucket
Hangs on Bucket
Bracket
Cutaway to
show inside
detail only
Tank Hold
down Bracket
1/4 - 20x1/2
Thumb Screw
Rear View
FIGURE 9
A-6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents