AEG Favorit 45250Vi Instruction Booklet page 5

en ru AEG F45250Vi 2-11-01 15.05
In daily use
Never place the dishwasher in operation if the mains cable, water
inlet or drain hose is damaged, or the control panel, or plinth area is
damaged such that the inside of the appliance is freely accessible.
In the event of a fault, first close the tap, then switch off the appliance
and unplug it from the mains. If the appliance is permanently wired to
the mains, remove the fuse.
When removing the electrical plug, grip the plug, not the lead.
Servicing and possible repairs must be carried out by a service
company authorized by the supplier. Use only spare parts supplied
by these. Never try to repair the dishwasher yourself, repairs carried
out by unauthorized or inexperienced persons can cause injury or
serious malfunctioning.
If the mains lead is damaged, or is to be replaced for a longer lead,
the cable (obtainable from AEG Service Force) must be replaced by
a service engineer authorised by AEG.
Do not put any solvents in the dishwasher. There is a risk of an
explosion!
Do not sit or stand on the open door, the appliance may tip over.
Before using special dishwasher salt, detergent or rinse aid, make
sure that the manufacturer of these products expressly specifies
their use in domestic dishwashers.
The water safety system protects against water damages. The follo-
wing requirements must be fulfilled:
- The dishwasher must remain connected to the mains supply when
switched off.
- The dishwasher must be correctly installed.
- Always shut off the water supply whenever the dishwasher is left
unattended for an extended period.
Sidan 5
Instruction book
5