Water Inlet - AEG Favorit 45250Vi Instruction Booklet

en ru AEG F45250Vi 2-11-01 15.05

Water inlet

The dishwasher is equipped with safety features which are to
prevent the water from going back to the fresh water system.
These features are according to current water technical safety
regulations.
The temperature of the water supply should not exceed 65° C and the
pressure should be between 80-1000 kPa (0,8 - 10 bar).
It is important to have a tap or stopcock,
positioned close to the dishwasher and with
easy access. Special mixer taps with dish-
washer connections are available, as well
as adaptors for older mixer taps. Connect
the inlet hose to a tap with a 3/4" pipe thread.
If necessary, use the restrictor (1/2") supplied.
The inlet hose must not be joined onto any
form of extension hose. If it is too short, the
entire hose must be replaced with a longer
highpressure hose, specially designed for
the purpose. The end of the hose, which is
connected to the dishwasher can be turned
in any direction. Loosen the retaining nut,
turn the hose, then retighten the nut.
Check that the nut is tight before the
machine is moved into position.
Sidan 33
Position- and connection instructions
33