NordicTrack NTEL07808.0 User Manual page 6

1.
To make assembly easier, read the
information on page 5 before you begin
assembling the elliptical exerciser.
Attach the Front Stabilizer (6) to the Frame (1)
with two M8 x 80mm Patch Screws (84).
2. Orient the Ramp (3) as shown. Then, insert the
Ramp into the Frame (1).
Attach the Ramp (3) with five M8 x 19mm Patch
Screws (82) and five M8 Split Washers (83).
3. While a second person holds the Upright (4)
near the Frame (1), connect the Upper Wire
Harness (110) to the Lower Wire Harness (111).
Tip: Avoid pinching the wires. Slide the
Upright (4) onto the Frame (1). Attach the
Upright with four M8 x 19mm Patch Screws (82)
and four M8 Split Washers (83). Do not tighten
the Patch Screws yet.
1
2
3
3
82
83
82
110
6
6
1
83
1
82
83
82
Avoid pinching
the wires
4
83
82
1
111
84
83
82