Audio Mode - Topfield TF 7700 HCCI User Manual

3.2.5 Audio mode

If you have the digital receiver linked to your television
via the component video connectors (Y, Pb and Pr) or
the HDMI connector, you have to toggle the video output
selection switch on the back panel to the YPbPr position.
Otherwise if you have connected it to your television via
the TV SCART connector, you have to toggle the switch
to the SCART position. The available values of the Video
Format option vary depending on which position you
toggle the switch to.
NOTE
You can enjoy only standard definition video with the following
connectors:
• Composite video connector (VIDEO)
• SCART connector (TV)
Basically, there are two audio sources as you can find two audio
sockets on the back panel of the digital receiver. You can enjoy
only one source or both of them in either stereo or mono. Set
the Sound Mode option as you desire.
Apart from this setting, you can change the sound mode with
the button. See §
The digital receiver can output two types of digital audio sig-
nals via the S/PDIF connector. One is an encoded signal, and
the other is a decoded signal. If your digital audio system does
not have a Dolby Digital decoder, you have to set the Digital
Output (Dolby Digital Only) option to PCM. Otherwise, set it to
Bitstream.
NOTE
If the service you are currently watching does not provide
Dolby digital, you cannot watch the programme with Dolby
3.2 Video and audio settings 21
5.2.4 for a detailed description.