Rear Panel - Pioneer DVL-V888 Operating Instructions Manual

Names and Functions

Rear panel

Digital Output Jack (Coaxial•Optical)
This is used for output of the digital audio signal
recorded on DVDs, CDs, Video CDs and digital audio
LDs.
Depending on the components connect, noise may
be generated.
Switching between PCM/∂ and PCM output is
possible. If your amp is not Dolby Digital(AC-3)
compatible, you should switch to PCM output.
(Refer to the chart on the right).
Performing settings
1 Turn amp volume down (to MIN).
2 Load a DVD disc and set to the Stop mode, press the
on the remote control.
¶ Main menu is displayed.
3 Select the OUTPUT setting with the
control.
4 Press digit button
DIG.OUTPUT .
5 Press digit button
on the remote control, and select PCM .
Digital Output
Audio digital output. Switchable
between PCM/∂ and PCM
output.
External
input jack
For connecting
external karaoke
sources such as a
cassette deck or MD
player.
S2 Video
output jacks
Video
output
jacks
Usually set to the OFF
switch.
70
Names and Functions
MENU
button on the remote
on the remote control, and select
Optical Digital Output
Audio optical digital output. Switchable
between PCM/∂ and PCM output.
AC-3 RF output (for LDs)
Audio output jacks
There are two sets of outputs, 1 and 2, which you
can simultaneously connect. Connect 1 to the TV,
and 2 to your AV amp.
Using the attenuator switch
=
OFF ON OFF ON
When enjoying karaoke,
switch it ON if the sound
is distorted.
Connect to the PCM/∂ jack, and select PCM from a menu.
Connect to the optical jack, and select PCM from the menu.
Connect to the PCM/∂ jack, and select PCM/DOLBY DIGITAL from the menu.
Dolby Digital (AC-3)
compatible amp
Connect to the optical jack, and select PCM/DOLBY DIGITAL from the menu.
Note
Output of karaoke sound (sound from mics, Key control etc.) is not
digital, so be sure to connect this player's audio output jack to your
amp's audio input jack (AUDIO IN).
Tip
When switched for PCM output.... For digital output to a regular amp
button
When switched for PCM/DOLBY DIGITAL output.... PCM audio is output as
Control output jack
Control input jack
that is not Dolby Digital(AC-3)
compatible, even audio recorded
in Dolby Digital is converted to
PCM output.
PCM, and Dolby Digital
audio is output as Dolby
Digital.
Power cord
connection terminal