Table of Contents
Advertisement
FILLING AND BLEEDING THE COOLING CIRCUIT
Filling and bleeding.
Fit the filling cylinder [1], with the adaptor [2] on the filling aperture.
Slowly fill the circuit with the coolant fluid.
Reclose the bleed screws when the liquid starts to flow out continuously without air bubbles.
NOTE : The filling cylinder [1] should be filled to the «1 Litre» mark to purge the heater matrix correctly.
Refit the air filter housing.
Start the engine.
Maintain an engine speed of 1500 to 2000 rpm, until the end of the second cooling cycle.
(Starting and stopping of the cooling fan).
Keep the filling cylinder full to the «1 Litre» mark.
Stop the engine after the second cooling cycle.
Remove the filling cylinder [1] with the adaptor [2].
Refit the expansion chamber cap.
B1GP09KC
97
Hide quick links:
Advertisement
Table of Contents
