CITROEN C2 2003 Handbook page 73

B1EP18HC
CHECKING AND SETTING THE VALVE TIMING
Setting the timing (continued).
Hold the tensioner roller, using a hexagonal spanner at «b».
Slacken the screw (9).
Remove the timing belt (10).
Refitting.
IMPERATIVE : Check that both the tensioner roller and the fixed roller turn
freely (no tight spots). If this is not the case, replace the rollers.
Fitting of the pulleys.
- Camshaft pulley
- Fuel high pressure pump pulley
The crankshaft pinion is located without a screw at the end of the crankshaft.
Fitting of the rollers.
IMPERATIVE : Check that the tensioner roller turns freely (no tight spot).
Otherwise, replace the rollers.
- Guide roller
- Tensioner roller
Check the condition of the seals at the camshaft and at the crankshaft pinion.
71
Engine : 8HX
: Tighten to 4,3 ± 0,4 m.daN.
: Tighten to 5 ± 0,5 m.daN.
: Tighten to 4,5 ± 0,4 m.daN
: Pre-tighten to 0,1 m.daN