Ford B-MAX Owner's Manual page 220

Note: If traffic announcement is on and you
select a preset or manual tune to a non
traffic announcement station no traffic
announcement will be heard.
Note: When you are listening to a non
traffic announcement station and turn
traffic announcement off and on again a TP
seek will occur.
Traffic Announcement Volume
Traffic announcements interrupt normal
broadcasts at a preset minimum level that
is usually louder than normal listening
volumes.
To adjust the preset volume:
• Use the volume control to make the
necessary adjustment during an
incoming traffic announcement
broadcast. The display will show the
level selected.
Ending Traffic Announcements
The audio unit will return to normal
operation at the end of each traffic
announcement. To end the announcement
prematurely, press TA or TRAFFIC during
the announcement.
Note: If you press TA or TRAFFIC at any
other time it will switch all announcements
off.
Automatic Volume Control
When available, automatic volume control
adjusts the volume level to compensate
for engine noise and road speed noise.
1. Press the MENU button.
2. Select AUDIO or AUDIO SETTINGS.
3. Select AVC LEVEL or ADAPTIVE
VOL.
4. Use the left or right arrow button to
adjust the setting.
5. Press the OK button to confirm your
selection.
B-MAX (CB2) Vehicles Built From: 25-06-2012, Vehicles Built Up To: 31-12-2013
Audio System
6. Press the MENU button to return.
Digital Signal Processing
Digital Signal Processing Occupancy
This feature takes into account the
differences in distance from the various
speakers in your vehicle to each seat. You
must select the correct sitting position for
the audio to be correctly set.
Digital Signal Processing Equalizer
Select the music category that most suits
your listening preference. The audio output
will change to enhance the particular style
of music chosen.
Changing the Digital Signal Processing
Settings
1. Press the MENU button.
2. Select AUDIO or AUDIO SETTINGS.
3. Scroll to the required digital signal
processing function.
4. Press the OK button.
5. Use the up and down arrow buttons to
select the required setting.
6. Press the OK button to confirm your
selection.
7. Press the MENU button to return.
News Broadcasts
Your audio unit may interrupt normal
reception to broadcast news bulletins from
stations on the FM waveband, radio data
system or other enhanced network linked
stations.
The display will indicate there is an
incoming announcement, during news
broadcasts. When the audio unit interrupts
for a news broadcast the preset volume
level will be the same as traffic
announcements.
1. Press the MENU button.
218