Ford Kuga Owner's Handbook Manual page 72

Clock setting
Note: This display is only present on
vehicles equipped with a programmable
auxiliary heater but no Ford audio or
navigation system. If the vehicle is
equipped with a Ford audio or navigation
system, the time is set on the audio or
navigation system. See separate audio or
navigation handbook.
Scroll to this display using the rotary
control and press SET/RESET. The
hours start to flash and can be set using
the rotary control.
Press the SET/RESET button to confirm
the setting and move to the minutes.
Proceed in the same way to set the
minutes and the date.
After setting the year and pressing
SET/RESET, the time and date are
stored.
Units of measure
To toggle between metric and imperial
units, scroll to this display and press the
SET/RESET button.
Toggling the units of measure using this
display will affect the following displays:
• Distance to empty
• Average fuel consumption
• Instantaneous fuel consumption
• Average speed
• Outside air temperature
• The temperature display in the
automatic climate control.
The units of measure for outside air
temperature and the automatic climate
control can be toggled independent of
the other displays. See General
information (page 66).
Information displays
70
Auxiliary heater programming
See Auxiliary heater (page 82).
To programme the auxiliary heater, scroll
to this display using the rotary control and
press the SET/RESET button.
Instant control
To switch on the programmable auxiliary
heater or fuel operated heater, scroll to
this display and press SET/RESET. The
cursor will change to a tick. The tick in this
display confirms that the heater is now
activated and will perform one heating
cycle.
AUX. HEATER ON will appear in the
display.
To switch off the programmable auxiliary
heater or fuel operated heater during a
heating cycle, scroll to this display and
press SET/RESET. The cursor will
change to a tick. The tick in this display
confirms that the heater is now
deactivated.
AUX. HEATER OFF will appear in the
display.
Programme times
Note: The programmed time is the time
at which you wish the vehicle to be warm
and ready to drive, not the time at which
the heater switches on.
Note: Times must be programmed at
least 70 minutes in advance of the time
you wish to set.
Note: The time and date must be
correctly set on the audio/ navigation
system or on the information display. See
Clock setting.
Four functions are available for setting the
times at which the vehicle should be
warmed up:
Seven days in the week