Table of Contents
Advertisement
4 - 2
CA10 User Guide
•
Window cleaning solution
•
Water
CAUTION
Always wear eye protection when handling cleaning agents. Read warning label on cleaning product
before using. If you have to use any other solution for medical reasons, please contact Motorola for
more information.
Cleaning the CA10 or Cradle Housing
Clean the CA10 with a soft cloth moistened with a diluted window cleaning solution or alcohol.
Cleaning the CA10 or Cradle Connectors
To clean the connectors on a cradle:
Remove the AC Line cord from the AC power outlet.
1.
Dip the cotton portion of the cotton-tipped applicator in isopropyl alcohol.
2.
Rub the cotton tip along the pins / contacts of the connector. Do not leave any cotton residue on the pins.
3.
Allow at least 10 to 30 minutes for the alcohol to air dry (depending on ambient temperature and humidity)
4.
before applying power to the cradle.
Cleaning Frequency
Frequency of cleaning frequency is at the customer's discretion, due to the varied environments in which the
CA10s are used. CA10s may be cleaned as frequently as required.
Troubleshooting the CA10
Troubleshooting the CA10
Table 4-1
Problem
CA10 does not turn on.
CA10 battery does not
charge.
Cause
CA10 battery is not charged. Fully charge the CA10.
The cradle is not powered.
CA10 is not seated
properly onto the cradle.
CA10 is removed from the
cradle while the battery is
charging.
Ambient temperature during
battery charging is too high
or too low.
Battery failed.
Solution
Check the cradle cable connections.
Verify the Power LED on the cradle illuminates green.
Remove and replace the CA10 on the cradle, ensuring
it is firmly seated.
The battery is not fully charged. Charge the CA10 until
the Status LED shows steady green.
Move the cradle and device to another location with
ambient temperatures between 0°C to +40°C (32°F to
104°F).
Contact service.
Advertisement
Table of Contents
Troubleshooting
