Vertex Standard VX-920 Operating Manual page 14

CALL/RESET
While the DTMF Paging System
This feature, if enabled, allows the user to change
the 3-digit Page Call code, used to call other simi-
larly-equipped stations. Press the assigned program-
mable key, followed by the three digits representing
the Page Call code of the station you wish to call.
Three tones will be heard after the last key is pressed
(the new code will now be transmitted).
The receiver squelch of the other station will be
opened, and you can begin communication.
While the 2-Tone/5-Tone Paging System
This feature, if enabled, press the assigned program-
mable key to send a 2-tone/5-tone sequential tone.
C 1 C 5
ALL TO ALL
Press the assigned programmable key to send a 2-
tone/5-tone sequential tone group which is pre-de-
fined.
O SW1
PTION
Press the assigned programmable key to toggle the
optional accessory "1" "On" and "Off."
12
A O
DVANCED PERATION
O
PTION
Press the assigned programmable key to toggle the
optional accessory "2" "On" and "Off."
Emergency
The VX-920 series include an "Emergency" feature
which may be useful for alerting another party moni-
toring on the same frequency as your transceiver's
channel.
Press the assigned programmable key to initiate an
emergency call. For further details contact your
Dealer.
REC/PLAY ( V
This function allows your radio to record a received
voice message, and to play back the recorded audio.
It requires installation of the optional Voice Record-
ing Unit.
Recording;
Press the assigned programmable key for 1.5 sec-
onds to enable the Voice Recording Mode. If the in-
coming signal is received, so as to un-mute the
squelch and pass audio, then received audio will be
recorded.
SW2
S
OICE TORAGE
VX-920 O
PERATING
)
: O
PTION
M
ANUAL