Page 1
® guide contains the basic instructions for operating your new Mini-Baja. While the Mini-Baja is great for first-time R/C drivers, it does require some mechanical experience and/or parental supervision for drivers under 12. It is critical that you read all of the instructions in order to operate your model correctly and avoid unnecessary damage.
The following is an overview of the various functions and adjustments found on the Mini-Baja radio system. Since the Mini-Baja operates on a radio signal you control, it is important for you to read and understand about all of these functions and adjustments before driving.
Page 3
TV channel. The transmitter you hold in your hand is like the TV station and the receiver in the Mini-Baja is like your TV at home that must be set to the correct channel to receive the signal your transmitter is sending.
Page 4
C: If the set-up button is not pressed for 20 seconds while in the Program mode, the ESC will exit the Program mode and the data will be saved. Slipper Adjustments The Mini-Baja is equipped with a slipper device offering both traction control and protection for the transmission. The slipper is primarily used...
This is really helpful when you are on slick, as well as high traction, surfaces. If your Mini-Baja turns too sharply and/or spins out easily, try turning the steering rate down by rotating the knob counterclockwise (to the left).
Page 6
Service/Repair Radio/Speed Control & Motor If you have any problems other than those covered in the troubleshooting section, please call the electronics service department at (877) 504-02. They will be able to give your specific problem additional attention and instruct you as to what needs to be done.
This would be good for short layouts or when running hotter motors. The pinion on the Mini-Baja offers the best balance of both. To change the pinion, remove the gear cover, loosen the motor screws, and slide the motor back.
Page 8
NOT threads inside the shock body. TIGHTEN yet! Note: Your Mini-Baja comes with 100wt shock fluid from the factory. Step 7 Step 8 Turn the shock over and use...