Table of Contents
Advertisement
MANUAL LIGHTING
PROcEDURE
1. Follow steps 1 through 6 under Lighting
Instructions, page 15.
2. Press control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow steps 9
through 11 under Lighting Instructions,
page 15.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 27). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 14.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 22).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Remote Selector Switch
in REMOTE Position
(Optional Remote Control)
Figure 22 - Setting the Remote Selector
Switch, Control Knob and Flame
Adjustment Knob for Remote Operation
16
OPERATION
Flame Adjustment Knob
ON
OFF
REMOTE
Control Knob
in ON Position
www.desatech.com
Continued
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 23).
To Lock press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock press both buttons together on hand-
held remote control until the light stops flashing.
The hand-held remote is now unlocked.
Control Button
Turns Burners
On and Off
Figure 23 - On/Off Hand-Held Remote
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 24). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
Digital Display Shows
Temperature and Settings
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or Off
Decreases Room
Temperature in
AUTO Mode
Figure 24 - Thermostat Hand-Held
Remote Control Unit (HRC200)
Control Unit (HR100)
AUTO
ROOM
SET
TEMP
TEMP
TEMP
LOCK
POWER
MANU
AUTO
ºC/ºF
Increases
Room
Temperature in
AUTO Mode
Turns
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
Auto
Setting
113084-01J
Advertisement
Table of Contents
