Table of Contents
Advertisement
8. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Figure 7
and Figure 10). Use an adjustable wrench
or a 12 mm socket to fasten step bolt.
Tighten step bolt until snug. Make sure
door moves freely.
9. Remove log box and heater from carton.
Place heater in stove as shown in Figure
9. Use bolts from hardware kit to attach
heater to stove.
10. Install door catch bolt (M8 x 1.25-55 mm
with two M8 hex nuts) into threaded hole on
stove body (see Figure 7). Use an adjust-
able wrench or a 12 mm socket. The catch
bolt has two hex nuts attached to it (see
Figure 11). Top nut is a bolt stop and bottom
nut is for door leveling adjustment.
11. Check general catch bolt alignment with
door claw. Make final adjustment and door
leveling after stove is in normal standing
position.
12. Carefully lift stove back up on its four at-
tached legs.
13. Remove gas log heater from carton.
Note: Do not pick up gas log heater by the
burner itself. This could damage heater.
Always handle the gas log heater by the
heater base only.
14. Fasten stove pan to stove with two M6 x 1
- 25 mm bolts. Use a flat washer and lock
washer with each bolt. Tighten bolts into
threaded holes on stove body (see Fig-
ures 7 and 9). Use an adjustable wrench
or a 10 mm socket.
15. Set top grates into stove top.
Door Hinge
Step Bolt Hole
Leg
Hole
Leg Hole
Figure 7 - Locating Threaded Holes
for Stove Bottom, Legs and Door
Attachment (Appearance May Vary
Depending on Model)
10
INSTALLATION
Door Catch Bolt
With Adjustable
Hex Nuts Hole
Front
Leg Hole
Holes for
Stove
Bottom
Leg Hole
Bottom Of
Stove Unit
www.desatech.com
Continued
Bottom Of
Stove Unit
Washers
Bolt
Leg
Figure 8 - Attaching Stove Legs
(Oxford™ Model Shown)
Stove Pan
Figure 9 - Attaching Stove Pan (Oxford™
Stove
Door
Door
Hinge
Step
Bolt
Bolt Shoulder
Figure 10 - Attaching Stove Door
(Appearance May Vary Depending on Model)
Door
Figure 11 - Catch Bolt and Door Claw
Bolt
Threaded Holes
in Stove Body
Model Shown)
Threaded
Hole
Door
Claw
Orientation
Washers
Stove
Bottom
Bolt Stop
Adjusting
Nut
Catch
Bolt
113084-01J
Advertisement
Table of Contents
