Adjusting The Brakes; Checking And Adjustment Of Throttle Wire; Checking And Adjusting The Choke Wire - Husqvarna Rider Pro 15 Operator's Manual

Adjusting the brakes

The parking brake (on the right) is adjusted as follows:
1. Remove the transmission cover.
2. Unhook the spring (A) from the screw (B).
3. Make sure the parking brake is released.
4. Adjust so there is 1 mm play between the outer
cable and the adjuster screw when you pull the
outer cable.
Adjust the adjuster screw using the nuts.
5. Tighten the nuts carefully to prevent damaging the
adjuster screw.
6. Refit the spring (A).
7. Check that the brake works.
WARNING!
Poorly adjusted brakes can
result in reduced braking power.
Checking and adjustment of the throttle
wire
Check that the engine responds to the throttle control
and that the correct engine speed is achieved at full
throttle.
If in doubt, contact the service workshop
If adjustment is necessary, adjust the lower wire as
follows:
1. Release the clamping screw that secures the wire
casing and set the throttle control to full throttle.
2. Check that the throttle wire is attached to the correct
hole in the lower lever, see diagram.
3. Pull the throttle wire casing to the far left and tighten
the clamping screw.

Checking and adjusting the choke wire

If the engine is producing black smoke or is difficult to
start then the choke wire (upper wire) may be incorrectly
adjusted.
If in doubt contact your service workshop.
If it is necessary to adjust the choke, proceed as follows:
1. Release the clamping screw that secures the wire
casing and set the choke control to maximum
choke.
2. Check that the throttle wire is attached to the upper
lever, see diagram.
3. Pull the choke wire casing to the far right and tighten
the clamping screw.
MAINTENANCE
23
English –