Drain Line Installation - GE Built-In Dishwasher Installation Instructions Manual

Dishwasher Installation
STEP 17 – CONNECT WATER SUPPLY
Connect water supply line to the 90° elbow.
• Slide compression nut, then ferrule over end of water line.
• Insert water line into 90° elbow.
• Slide ferrule against elbow and secure with compression nut.
IMPORTANT
– Check to be sure that door spring does
not rub or contact the fill hose or water supply line. Test by
opening and closing the door. Reroute the lines if a rubbing
noise or interference occurs.
Figure EE
STEP 18 – CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
• Cut drain hose connector on the marked line, if required, to fit
the inlet port.
IMPORTANT: Do not cut corrugated
Cutting Line
1"
5/8"
Figure FF
• If a longer drain hose is required, and you did not purchase
10' long GPF10L drain hose, add up to 3-1/2' of length for a
total of 10' to the factory-installed hose. Use 5/8" or
7/8" inside diameter
hose and a coupler
923-10A
to connect the
two hose ends.
Secure the
connection with
hose clamps.
Hose Clamp
Figure GG
Compression Nut
Ferrule
Hot Water
90° Elbow
Supply Line
90° Elbow
Door Spring
05A-1183CC
portion of hose
Hose Clamp
Coupler
05A-1183DD
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR
PROPER DRAIN OPERATION.

DRAIN LINE INSTALLATION

• Connect drain line to air gap, waste tee or disposer using
the previously determined method.
• Secure the drain hose to the air gap, waste tee or disposer
with clamps.
Method 1 – Air gap with waste tee or disposer
Insert the drain hose into the air gap as shown.
Waste Tee Installation
Figure HH
Method 2 – High Drain Loop with the Waste Tee or Disposer
923-10Q
Route the drain hose of the dishwasher to a minimum height of 32" from
Fasten drain hose at least at
the floor with the supplied hanger as shown.
32" height with hanger supplied
32"
Min.
18"
Min.
Waste Tee Installation
Figure II
05A-1183FF
IMPORTANT
– One of the above methods must be
used or dishwasher will not operate properly.
IMPORTANT
– When connecting
drain line to disposer, check to be sure
that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
Tip: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
Disposer Installation
923-10R
Fasten drain hose at least at
32" height with hanger supplied
32"
Min.
18"
Min.
Disposer Installation
05A-1183GG
Remove
Hopper
923-10N
Plug
13