Husqvarna LOGTH2448T Operator's Manual page 21

02965
NOTE: Be sure mower side suspension
arms (A) are pointing forward before slid-
ing mower under tractor.
3. Slide mower under tractor until it is
centered under tractor.
4. ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS - Position hole
in arm over pin (B) on outside of tractor
chassis and secure with washer and
retainer spring.
5. Repeat on opposite side of tractor.
A
6. ATTACH REAR LIFT LINKS (C) - Lift
rear corner of mower and position
slot in link assembly over pin on rear
mower bracket (D) and secure with
washer and retainer spring.
7. Repeat on opposite side of tractor.
A
B
8. Turn steering wheel to position wheels
straight forward.
9. ATTACH FRONT LINK (E) - Work from
left side of tractor. Insert rod end of link
assembly through front hole in trac-
tor front suspension bracket (F) and
secure with large 7/16 retainer spring
(G) through hole in link located behind
the bracket.
10. Insert other end of link (E) into hole in
front mower bracket (H) and secure
with washer and small 5/16 retainer
spring (J).
F
G
7/16
11. Disengage belt tension rod (K) from
locking bracket (L).
12. Install belt onto engine clutch pulley (M).
IMPORTANT: Check belt for proper rout-
ing in all mower pulley grooves.
21
C
D
5/16
H
E
J
M