Trouble Shooting; Troubleshooting - KTM 50 SENIOR ADVENTURE 2006 Owner's Manual

TROUBLE SHOOTING

If you let the specified maintenance work on your motorcycle be carried out, disturbances can hardly be expected. Should an error
occur nevertheless, we advise you to use the trouble shooting chart in order to find the cause of error.
We would like to point out that many operations cannot be performed by oneself. In case of uncertainty, please contact a KTM-dealer.
TROUBLE
Engine fails to start
30
Engine without idle running
»
CAUSE
Operating error
The motorcycle has been out of
operation for a longer period of
time. Therefore old fuel has accu-
mulated in the float chamber
Fuel supply interrupted
Electrode distance too large
Plug fouled by oil, wet or bridged
Ignition wire or spark plug connec-
tor damaged
Kill button wire or
short-circuit switch faulty
Loose ignition cable connectors
Spark too weak
Water in the carburetor and jets
blocked
Idle adjusting screw out of
adjustment
Ignition system damaged
Wear
REMEDY
Open fuel tap, replenish fuel, do not use choke
The easily inflammable components of the new fuels evapo-
rate during longer periods of standstill.
When the motorcycle has been out of operation for more
than a week, it is therefore recommended to drain the old
fuel from the float chamber. The engine will immediately
start off when the float chamber is filled with new fuel.
Close fuel tap, loosen fuel hose at carburetor, lead into a
basin and open fuel tap,
– if fuel leaks out, clean carburetor
– if no fuel leaks out, check tank ventilation, i.e. clean fuel
tap
Reduce electrode distance (0.60 mm)
Clean spark plug or renew
Dismount spark plug, connect ignition cable, hold to ground
(blank place on engine) and actuate kickstarter, a strong
spark must be produced at the spark plug
– If no spark is produced, loosen spark plug cap from igni-
tion cable, hold about 5 mm from ground and actuate
kickstarter
– If a spark now occurs, replace spark plug cap
– If no spark is produced, control ignition system
Disconnect black colored cable from short circuit button at
ignition coil and check ignition spark. If the spark is O.K.
repair defective part of cable or ignition switch
Inspect cable connectors
Examine ignition system
Dismantle and clean carburetor
Readjust idle running or replace idle adjusting screw
Examine ignition system
Overhaul engine