Intermec EasyCoder PX4i User Manual page 122

EasyCoder PX4i User's Guide (IPL Version)
In the Test/Service part of the Setup Mode, you can test the label
stop sensor if you have a detection problem.
The menu provides only indications from the label stop sensor
unit. The testing menu can determine if the sensor unit is not
physically in position, is blocked by dust or stuck labels, or is
defective in some way. Furthermore, this is an aid if media has
detection complications.
Note: There is no way to adjust the LSS-function. The menus
only indicate values as obtained from the LSS.
• Check that the printer is set up for the type of media loaded
in your printer. Navigate to Setup Mode > Media > Media
type > Gap, Mark, or Continuous.
• Lift and lower the printhead, then press the <Feed/Pause> key.
• Make sure that there is a label—not a gap or mark—at the
LSS.
• Check that the media is routed as close to the center section as
the guides allow.
Enter the Setup Mode and navigate to Setup Mode > Test/
Service >LSS Test >LSS Auto.
Return to the centered cursor position by pressing the Down key.
Chapter 11 — Adjustments
The menu should look like
this, with the cursor placed in
the center.
Gap detection: Lift the
printhead and pull out the
media slowly. When the LSS
detects a gap or a detection
slot, the cursor moves to the
right.
Mark detection: Lift the
printhead and pull out the
media slowly. When the LSS
detects a black mark, the
cursor moves to the left.
107