Table of Contents
Advertisement
wArning
Never use water for cleaning your product, use only a dry cloth. Do not clean with chemicals or solvents as
some can destroy critical plastic parts.
Switch off and disconnect from the mains power supply before cleaning your product.
n
Always empty the collection bag.
n
Always store the product in a dry place ensuring the cable is not likely to be damaged on the sharp edges etc.
n
cleAning The collecTion BAg
Empty the collection bag after each use to avoid deterioration and obstruction of the air flow which will reduce the
n
performance of the unit.
Clean the collection bag as needed. With eye protection on, turn the dust bag inside out after initial emptying and
n
vigorously shake out the dust and debris.
ProBleM
Motor won't start
Material is not
sucked in properly
(reduced
vacuuming power)
MAinTenAnce AnD STorAge inForMATion
Prior to cleaning or any maintenance, always ensure the power plug has been removed from the electric power supply.
When you have finished using the blower vac, always check to make sure the product is clean and free of dirt and
debris. It is especially important to check and clear debris around the quick change lever. To check this area, remove
the collection bag and ensure the discharge side of the tube is free of debris and dirt. Operate the selector lever
backwards and forwards to ensure correct operation
Do not use solvents to clean the blower vac.
n
Store the blower vac in a dry place, and out of reach of children.
n
Power corD MAinTenAnce
If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer's agent, or an
authorised service centre in order to avoid a safety hazard.
TrouBleShooTing
PoSSiBle cAuSe
1. No mains power (power failure)
2. Connection lead wire defect
3. Motor or switch defect
4. lower tube hasn't been telescoped out to
its full length.
1. Machine is clogged or blocked
2. Bag too full
3. Speed setting too low (only for garden
vac with fully variable speed control)
Waste electrical products should not be disposed of together with household waste. Please
recycle where facilities exist. Check with your local authority or retailer for recycling advice.
engliSh
MAinTenAnce
SoluTion
1. Check power source.
2. Replace lead or have lead checked
3. Contact Ryobi customer service centre or
4. Pull the lower tube out to its full length.
1. Clean machine
2. Empty bag
3. Adjust to higher speed
DiPoSAl
5
(electrician), never use defect lead
your original place of purchase.
Hide quick links:
Advertisement
Table of Contents
