Selecting Or Changing The Startup Device Sequence; Advanced Settings; Exiting From The Setup Utility Program - Lenovo ThinkCentre 7258 User Manual

Selecting or changing the startup device sequence

To view or permanently change the configured startup device sequence, do the
following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. Select Startup.
3. See the information displayed on the right side of the screen.
4. Select the devices for the Primary Startup Sequence, the Automatic Startup
5. Select Exit from the Setup Utility menu and then Save Changes and Exit.
If you have changed these settings and want to return to the default settings, select
Load Optimal Settings from the Exit menu.

Advanced settings

On some computer models, the Advanced menu includes a setting to enable or
disable HyperThreading. This feature works only with HyperThreading-aware
operating systems, such as Windows Vista. The default setting for HyperThreading
is Enabled. However, if you select Set Defaults and are using an operating system
other than Windows Vista, your computer performance might be degraded.
Therefore, you should always set HyperThreading to Disabled unless you are sure
your operating system supports HyperThreading.

Exiting from the Setup Utility program

After you finish viewing or changing settings, press Esc to return to the Setup
Utility program menu (you might have to press Esc several times). If you want to
save the new settings, select Exit → Save Changes and Exit. Otherwise, your
changes will not be saved.
58
User Guide
page 55.
Sequence, and the Error Startup Sequence.